Productsc400 four inch hydrocyclone specifications

BF Flotation Cell

BF flotation cell has two types: type I and type II. Type I is improved as suction cell referring to model SF; type II is improved as direct flow cell referring to model JJF.

more+

Cyclone Unit

Each feeding inlet of Xinhai cyclone unit is installed knife gate valve independently developed by Xinhai. This valve with small dimension reduces the diameter of cyclone unit.

more+

Hydraulic Cone Crusher

The supports at both ends of cone crusher main shaft, scientific design of crushing chamber, double insurance control of hydraulic and lubricating system.

more+

Overflow Type Ball Mill

Wet type overflow ball mill is lined with Xinhai wear-resistant rubber sheet with excellent wear resistance, long service life and convenient maintenance

more+

Grid Type Ball Mill

Wet type grid ball mill is lined with Xinhai wear-resistant rubber sheet with excellent wear resistance design, long service life and convenient maintenance.

more+

Round Vibrating Screen(YA)

Ring groove rivets connection, plate type screen box, advanced structure, strong and durable Vibration exciter with eccentric shaft and eccentric block, high screening efficiency, large capacity

more+

Jaw Crusher

Xinhai improves the traditional specification of crushing chamber by adopting high speed swing jaw and cambered jaw plate.

more+

Hammer Crusher

High-speed hammer impacts materials to crush materials. There are two ways of crushing (Wet and dry)

more+

Jig

The cone slide valve is adopted; the failure rate is reduced by 80%; low energy consumption;the separation of different material, improvement of the processing capacity by more than 35%.

more+

Energy Saving Ball Mill

Cylindrical energy saving grid ball mill is lined grooved ring plate which increases the contact surface of ball and ore and strengthens the grinding.

more+

Cylinder Energy-Saving Overflow Ball Mill

20-30%. Rolling bearings replace slipping bearings to reduce friction; easy to start; energy saving 20-30%

more+

SF Flotation Cell

Both sides of the impeller with back rake blades ensures double circulating of slurry inside the flotation tank. Forward type tank, small dead end, fast foam movement

more+

THE SIZING AND SELECTION OF HYDROCYCLONES By Richard

4. Pressure drop – 69 kPa 10psi. 5. Cyclone geometry – “standard cyclone” as described above .. weight. Underflow becomes ball mill feed. Specific gravity of solids is 2.9 and estimated circulating . Cyclone Diameter Inches. Figure 5.

more+

Hydrocyclones - Herbold Meckesheim

Hydrocyclones are being offered for similar separation Specifications are not binding and subject to change without notice. Edition 03 Units in Inch. Model.

more+

Hydrocyclone Separator F5000 - Bermad, Inc

The BERMAD F5000 Hydrocyclone Separator is an efficient device, separating over 90% of Available Sizes: ¾", 1", 1½", 2", 3", 4", 6", 8" L. T. Weight. Inch. Inch. Inch. Inch. Inch. Inch. Inch. Inch. Inch lbs. 50307M2059102BU. ¾". ½". 3". 16**.

more+

Download Data Sheet USA - Rivulis

The Rivulis F1000 Hydrocyclone Sand Separator creates a centrifugal action that Inch. Flow Rate psi. 3. 94.5. 115.8. 133.7. 149.5. 163.7. 176.9. 4 x 3. 136.2 Please consult with an irrigation specialist and technical specifications for

more+

MHC™ Hydrocyclones - Xinhai

Xinhais new MHCTM Series hydrocyclones delivers a high unit capacity and exceptional separation efficiency for a wide range of classification duties.

more+

PRE Post:the processs in mining ores in rivers
NEXT Post:unique design hot sale centrifugal slurry pump

1993-2018 Xinhai Machine . All rights reserved | Design by Xinhai